Total TSGLI2001, Quick Start Manual

Page: 9 / 12

9
•
Clean containers and tubes with suitable cleaning tools.
•
Wash the tank with water or the like.
• Tighten the tank.
Note: Use only solvents with a flash point greater than 37.8ºC.
•
Turn on the device and inject solvent or water into a container.
Note: When a tube is not used, solvent or water is deposited in addition to the container.
Therefore, the air accumulates in the current volume.
• Repeat the above procedure if there is a clear solvent or water leak at the nozzle.
•
Power off the device.
•
Then empty the tank completely. Always keep the container seal free of paint
residue and check for damage.
•
Clean the outside of the gun and cup with a cloth soaked in solvent and water.
• Unscrew the nut, remove the air cap. Clean the air cap and nozzle with a brush
and water or the like.
Note: Never clean the spray gun nozzle or air holes with sharp metal objects.
Maintenance and troubleshooting
Maintenance
Make sure the tool is unplugged from power before performing any maintenance.
•
Keep the ventilation slots clean and free of obstructions. If possible, blow
compressed air through the vents to remove internal dust (safety glasses should
be worn when performing this process).
• Keep the outer casing of the tool clean and free of grease. Do not wash with
water or use solvents or abrasives. Use only mild soap and a damp cloth to clean
the tool.
•
Never let liquid get inside the tool. Never immerse any part of the tool in liquid.
•
Always store your power tool in a safe, dry place.