Total TRSLI1151, Manual

Page: 9 / 13

9
Tool speed is increased by increasing pressure on the switch trigger. Release the switch
trigger to stop. After use, always press the lock button from side A.
electric brake
This tool is equipped with an electric brake. If the tool consistently does not stop quickly
after releasing the switch trigger, take the tool to your official Total dealer.
Set up
Attention
Always make sure the tool is turned off and the battery removed before doing any work
on the tool.
Mounting
Installation or removal of the saw blade
Caution
Always clean any chips or foreign matter adhering to the blade and around the blade
clamp. Failure to do so may cause insufficient blade tightening, resulting in serious injury.
To install the reciprocating saw blade, always make sure that the blade clamp lever (part
of the blade clamp sleeve) is in the released position on the insulation cover before
inserting the reciprocating saw blade. If the blade clamp lever is in the fixed position, turn
the lever in the direction of the arrow so that it can be locked in the released position.
.
1. Blade holding lever 2. Released position 3. Fixed position
Insert the reciprocating saw blade into the blade clamp as far as it will go. The blade
clamp sleeve rotates and the reciprocating saw blade is fixed. Make sure the
reciprocating saw blade cannot be pulled out even if you try to pull it out.