Total THSPP2021, Operating Instructions Manual

Page: 4 / 6

4
Cleaning and storage
Cleaning
Attention
Always make sure the tool is turned off and the battery cartridge removed before
adjusting or verifying function on the tool.
•
Always clean your pressure sprayer after spraying.
• Use the pressure sprayer with clean water only (possibly with the addition of dish
detergent) and spray empty.
• Use the pressure sprayer with clean water only (possibly with the addition of dish
detergent) and spray empty.
• The valves, the suction hose and the nozzle
④
are cleaned.
• In the case of exterior dirt on the cap and tank, thoroughly clean the thread of the
area and the O-ring
⑦
of the thread.
Storage
•
Clean pressure sprayer.
• Keep your pressure sprayer in a place protected from frost.
Problem solving
Problem Possible cause Solution
Has no pressure
Spray nozzle
①
too
slightly kinked.
Screw on the spray
nozzle
①
with more
force.
Pump tube
⑧
It is loose. Screw the pump tube
⑧
tightest. Check the
correct position of the
O-ring
⑦
.
Change the sealing cap
⑩
.
O-ring
⑦
it is not seated
correctly.
Closing cap
⑩
It's
defective.
The pressure sprayer
does not spray, even if
there is enough
pressure or only sprays
with a weak spray
pattern.
Nozzle
④
It's blocked.
Unscrew the nozzle
④
and clean it.
The filter
⑨
is clogged. Remove the filter
⑨
and
clean it.
It is difficult to open and
close the container.
The pressure in the
container is too high.
Completely release the
pressure in the
container using the
safety valve
⑥