Total TG1252306, Instruction Manual

Page: 9 / 15

9
Install or remove disk protection
When using a multi-disc grinding wheel, flexible wheel or wire wheel brush, the wheel
guard must be installed on the tool so that the closed side of the guard always points
towards the user.
•
Mount the blade guard with the protrusion on the blade guard band aligned with
the notch in the bearing frame.
•
Rotate the wheel guard about 180 degrees counterclockwise.
•
Make sure to firmly tighten the screw.
• To remove the protection, follow the installation procedure in reverse.
Mounting the discs
Always use the supplied protector when the multi-disc grinding wheel is on the tool. The
blade can break during use and the guard helps reduce the chance of personal injury.
•
Mount the inner flange on the shaft.
• Place the disc on the inner flange and screw the locknut or outer flange with its
projection facing down (facing the disc).
• To tighten the locknut or outer flange, press firmly on the shaft lock so that the
shaft cannot rotate
• Then use the locknut wrench and tighten firmly clockwise.
•
To remove the disk, follow the installation procedure in reverse.
1. Wheel guard
2. Screw
3. Bearing box
1. Out flange
2. Depressed center grinding wheel
3. Inner flange
1. Spanner
2. Shaft lock