11
The clutch will slip at various levels of torque when set to number 1 to 15. Clutch does
not work at the mark .
Before actual operation, insert a trial screw into your material or a duplicate piece of
material to determine what level of torque is required for a particular application.
1. Adjusting ring 2. Graduation
3. Arrow
Mounting
Attention
Always make sure the tool is turned off and the battery cartridge removed before doing
any work on the tool.
Bit Installation or Removal
1. Sleeve
2. Close
3. Ablaugh
•
Rotate the sleeve counterclockwise to open the chuck jaws.
•
Place the bit in the chuck as far as it will go.
•
Turn the sleeve clockwise to tighten the chuck.