ATTENTION
ATTENTION
Joint Method
Assemble Method
Attach the Rail before assembly.
Loosen the OT Splice Screw and insert by
sliding along the Track groove.
Inset the Splice Pin into the opening of a Track.
(If insertion is difficult, tap with a wooden
hammer or similar tool.)
Inset the other Track into the OT Splice.
(If insertion is difficult, cover the Pulley with a
cloth and tap with a wooden hammer or similar
tool.)
Position the Tracks so that the joint section is
at the center of the OT Splice, then tighten the
screws of the OT Splice.
Check to confirm that the OT Joint is securely attached to the Rail.
Do not cut the Drive Belt of the Track.
If cut, the product will not be finished to the specified width. (The Progress 50
Rail set comes with a precut Track and Drive Belt.)
Before assembly, position the
Track, Drive Belt, End side Pulley
and Motor side Pulley as shown to
the right.
Before assembly
Track
Belt
End side Pulley
Motor side Pulley
: Place with the groove up.
: Position so that the marked
end is on the right.
: Place on the left side.
: Place on the right side.
Assemble Method
Insert the Drive Belt from the
right-hand side of the Track, inserting
it all the way to the left-hand side.
(The Belt should be inserted into the
near side groove of the bottom Rail.)
Place the right end of the Drive Belt
through the End side Pulley.
(This can be done by pushing the
tip of the Drive Belt into the Pulley.)
Attach the Belt Joint and Belt Joint
Cover to the left end of the Drive
Belt.
Attach the Belt Joint to the tip of the
Belt. Attach the Belt Joint and Joint
Cover until they click into position.
Track
OT Splice
Splice Pin
①
①
①
②
②
③
③
④
E side Pulley
M side Pulley
Track
Drive Belt
E side Pulley
Belt Joint
Belt Joint Cover
