P. 12
If the product installation height is 3010mm or
higher, Louver operation with Operation Wand is
not available.
Turn the Operation Wand and adjust the Louver
to be perpendicular to the Head Rail.
Slide the Operation Wand until Louver is in the
position and release your hand.
When closing the Louver completely, push the
base of the Operation Wand into the end to
avoid pull back.
Opening and Closing the Louver
(Wand Operation)
Caution
To prevent damage, make sure the Louvers are perpendicular to the rail when
opening/closing.
Pull the Operation Wand gently. If pulled strongly, the Louver will move rapidly and may
become misaligned, which will cause to align it untidily.
When closing a Louver that is moved to the side, pull the Operation Wand slowly. If
pulled quickly, the Louver slats will swing with great force, and a gap may appear
between the closing side and the Operation Wand being pulled on the opposite side. If
this occurs, close the gap using the Operation Wand that was moved.
Operation Wand
Operation Wand
Indicates the product specifications.
P. 13
Maintenance Sticker
Your purchased product has an affixed maintenance sticker showing information related to the
product. Please refer to this maintenance sticker when inquiring about the product or for repairs.
Indicates the shipping date.
Product name
Closing configuration
Slat code
Product
width
Product
height
Operation
position
Installation height
Rear of the Head Rail
Operation Wand
Drive Cord
Cleaning
Remove dust by wiping with a hand mop or dry cloth.
If the Louvers become dirty, wet a cloth and tightly wring, then lightly wipe the Louvers.
(Once the Louvers become wet, even by water, there may be an instance of a slight color
change. Please handle them with care.)
