Toshiba XM-7002B, Specification

Page: 2 / 32

XM-7002B Rev.1.0
Notice
1.This product has no over-current protection circuit.
System should have appropriate over-current protection.
Toshiba Corporation makes no warranty of damages caused by no over-current protection.
2.This has a little possibility of errors.
To prevent damages and injury caused by the above, careful consideration for the safety and integrity
should be taken in the system design.
Do not use this product in a system that may cause hazard to human being or material loss caused by
the failure, loss of data and/or errors of this product.
3.Do not disassemble or modify this product.
Or, reliability, safety and performance can not be guaranteed.
4.Turn off the system power before mounting/removing this product.
Or, it may cause failure or damage.
5.Because the Interface connector of this product allows insertion of only one side direction, ascertain
direction carefully to insert the connector.
6.To built this product in an equipment, handle it only in electrostatically safe environment.
Do not touch connecting terminal directly or the product may be damaged by electrostatic energy.
7. This product can playback discs based on the format described in item 3.1.(1). Do not load a disc
which is not based on the item (discs of which outside is cut unevenly and is not a normal circle, etc.)
or a disc with its weight unbalanced excessively.
A very high speed rotation is carried out inside the product, so abnormal vibration and malfunction may
occur if disc described above is loaded.
8. When a disc cannot be ejected because of same troubles, etc., turn off the unit and eject the disc using
the emergency eject mechanism after passing more than 1 minute.
When the emergency eject is carried out while the power is on or immediately after the power off, the disc
may be eject in a rotating status. We do not assure if the disc is damaged by this.
9. Do not apply excessive force during the eject operation. The disc load inside the product may be ejected
in a rotating status.
Should the disc be damaged by the above action, we do not warranty against that.
10. In the instruction manual of your product, statement described in “Safety Instruction Manual “attached
to this product, the statement of item 2 and 8 above, and other required statements should be
mentioned for thorough understanding by the users.