DISASSEMBLY INSTRUCTIONS
B1-3
1-10: VCR DECK (Refer to Fig. 1-10)
NOTE
Do not remove the cable at the FE Head section. The FE
Head may be damaged if you remove the cable by force.
1.
2.
3.
4.
5.
6.
7.
Move the Cassette Holder Ass'y to the back side.
Remove the screw
1
.
Remove the FE Head.
Remove the 3 screws
2
.
Remove the screw
3
.
Disconnect the following connectors:
(CP1001, CP4501 and CP4505).
Remove the AC Head Cover and VCR Deck in the
direction of arrow.
Fig. 1-10
1-11: VCR PCB (Refer to Fig. 1-11)
1.
2.
3.
Remove the 4 screws
1
.
Remove the AV Jack Shield.
Remove the VCR PCB in the direction of arrow.
FE Head
2
2
2
VCR Deck
AC Head Cover
1
Bottom Plate
3
1
1
1
VCR PCB
Bottom Plate
1
AV Jack Shield
Fig. 1-11
1-9: OPERATION PCB/DVD PCB/DVD DECK
(Refer to Fig. 1-9)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Short circuit the position shown in Fig. 1-9 using a
soldering iron. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Remove the 2 screws
1
.
Remove the Operation PCB in the direction of arrow (A).
Remove the 2 screws
2
.
Remove the Front Shield in the direction of arrow (B).
Disconnect the following connectors:
(CP2601, CP2602 and CP2603).
Remove the 4 screws
3
.
Remove the DVD Deck in the direction of arrow (C).
Remove the 2 screws
4
.
Remove the DVD PCB in the direction of arrow (D).
Fig. 1-9
Short circuit using a
soldering iron.
Pick Up PCB
DVD PCB
4
4
(D)
3
3
3
3
1
1
2
2
(A)
(B)
(C)
Front Shield
Operation PCB
DVD Deck
Angle Deck
NOTE
Before your operation, please read “PREPARATION
OF SERVICING”.
Use the Lead Free solder.
Manual soldering conditions
• Soldering temperature: 350
±
5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux
smoke away from it.
When installing the DVD Deck, remove all the soldering
on the short circuit position after the connection of Pick
Up PCB and DVD PCB connector.
1.
2.
3.
4.
5.
CP2601
CP2602
CP2603
CP1001
CP4501
CP4505
