Maintenance
Maintenance of the main unit
Wipe off stain lightly with a soft cloth. If stain is severe, wipe it off
with a cloth damped with neutral detergent solution and wrung
tightly, and dry it with a dry cloth.
• Do not use benzene or thinner, etc. Do not spray any volatile
chemical such as insecticide on the cabinet.
CD pickup (lens)
If the lens in the CD mount is stained, the CD may skip or cannot
be played.
Blow the lens a few times with a commercially available blower,
and remove the dust using the tip of a brush. To remove stains
such as fingerprints, damp a cotton swab with commercially
available lens cleaner, and wipe the lens lightly with it by drawing
circles outward from the center.
When you suspect a failure
Phenomenon
Cause
Remedy
Common unit
No sound is output.
• The power plug is disconnected.
• The volume level is low.
• The source is not switched properly.
• Insert the plug fully.
• Adjust the volume level.
• Switch the device to the proper source.
Speaker
No sound is output from
speakers.
• The speaker cord is disconnected.
• Connect the speaker cord to the SPEAKER
OUT terminals firmly.
The speaker does not
light up.
• The cord to SPEAKER LIGHT is disconnected.
• Connect the cord to the SPEAKER LIGHT
terminals firmly.
CD player/USB memory section
Replay does not start.
• The CD is upside down.
• The CD is stained.
• The MP3 file is not playable.
• Insert the CD with the label facing up.
• Wipe off the dirt.
• Make sure the file is a playable MP3 file.
Sound skips.
• The CD has large scratches or warp.
• The device is in a location with vibrations.
• The lens of the CD mount is stained.
• Replace the CD.
• Place it in a location where there is no
vibration.
• Clean the lens.
Device cannot be
detected.
• The device is not connected properly.
• Connect the device properly.
Radio section
Hard to listen because of
a lot of noises.
• The device is affected by power supply noise.
• The device is affected by noise due to a motor,
electric appliance such as fluorescent lights, or TV.
• The radio wave is weak.
• Remove the power plug and insert it again.
• Keep the device away from the noise source.
• Turn off the TV.
• Adjust the antenna.
Notes
• If the device does not operate or display properly while the CD/USB is played back, press the [ ] button once to turn off the power, and
disconnect the power plug and connect it again. Then, set the device back to the CD or USB mode and play back the CD/USB.
• The cabinet becomes slightly hot in some parts when the device has been used for a long period of time, it is not a failure.
Specifications
Bluetooth® section
Bluetooth® spec.
Bluetooth® standard Ver. 2.1+EDR,
Class 2
Supported profile
A2DP, AVRCP
Frequency range
2.4GHz (2.402 to 2.480GHz)
Service distance
Approx. 10m
CD player unit
Number of channels
2-channel stereo
Playable disk
CD (discs recorded in the CD-DA
format)
CD-R/RW (discs recorded in the
CD-DA and MP3)
USB memory section
Playback format
MP3 (MPEG-1 Audio Layer3)
Supported memory
USB 1.1 or USB2.0
Memory
32MB to 32GB USB memory (sold
separately)
Playable USB memory
USB-IF certified product
Radio unit section
Receiving frequency
FM: 87.5 to 108MHz
Common unit
Power Supply
AC 100-240V 50/60Hz
Power consumption
1
5
0 W
Actual maximum
output
200 W × 4
Speaker
Speaker unit: 209 mm cone type
(3
) × 2
Dimension : 310 (D) × 273 (W) ×
415 (H) mm
Mass: Approx. 6.25 kg × 2
LINE IN input terminal
LINE IN-1: 3.5 stereo mini-jack
LINE IN-2: Audio L/R output (RCA)
Maximum outside
782 (D) × 355 (W) × 484 (H) mm
Mass
Approx. 18.6 kg
Accessories
Remote control (Battery included),
FM wire antenna, Operation Manual
The specifications and appearance may be subject to modification
without prior notice.
The label is located on the bottom enclosure.
1-1-8, Sotokanda, Chiyoda-ku Tokyo 101-0021, Japan
