Toshiba TLP X4100, Owner'S Manual

Page: 14 / 48

14
S–VIDEO
R–AUDIO–L
VIDEO/Y Cb/Pb Cr/Pr
VIDEO/Y Cb/Pb Cr/Pr
RESET
CONTROL PORT
USB
AUDIO 1 AUDIO 2
ANALOG DIGITAL(DVI-D)
INPUT 1
INPUT 2
INPUT 3
R/C JACK
G B R H/V V
(MONO)
ON
1
DIP
ON
OFF
2 3 4 5 6
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFF ON ON
ON ON
ON ON
OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
1 2 3 4 5 6
OFF OFF ON ON ON ON 21" MODE (1152 x 870)
CONNECTING PROJECTOR
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable
Monitor Output
Desktop type Laptop type
Control Cable
for Serial Port
Terminal
Serial port
PS/2 port Audio Output
CONTROL
PORT
COMPUTER
AUDIO IN 1 or 2
COMPUTER IN ANALOG
Use one of these Control
Cables corresponding with
terminal of your computer.
ADB port
Cables used for connection
(
✽
= Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port
Control Cable
for ADB Port
Audio
Cable
✽
(stereo)
NOTE :
When connecting cable, power cords of both
a projector and external equipment should
be disconnected from AC outlet. Turn a
projector and peripheral equipment on
before computer is switched on.
USB port
MAC Adapter
Set slide switches
according to chart
below.
• VGA Cable (HDB 15 pin)
• DVI-Digital Cable (for Single Link T.M.D.S.)
✽
• BNC Cable ✽
• Control Cable for PS/2 Port, Serial Port or ADB Port
• USB Cable ✽
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables (RCA x 2 and Mini Plug (stereo) x 1)
✽
Terminals
of a Projector
Terminal Terminal
DVI
Cable
✽
Monitor Output
USB
COMPUTER IN DIGITAL
Set switches as shown in table
below depending on RESOLU-
TION MODE that you want to
use before you turn on projec-
tor and computer.
◆
MAC ADAPTER
USB
Cable
✽
BNC
Cable
✽