Toshiba TLP-X2000B, Service Manual

Page: 60 / 91

Chapter 7
7-3
Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2] ,
and press the buttons,
[Input] , [On/Standby] and [Keystone] simultaneously.
2) While the Volume adjustment bar is displayed on the screen, set value to [0] ,
and press the buttons,
[Input] , [On/Standby] and [Keystone] simultaneously.
3) While the Volume adjustment bar is displayed on the screen, set value to [0] ,
and press the buttons,
[Input] , [On/Standby] and [Keystone] simultaneously.
4) While the Volume adjustment bar is displayed on the screen, set value to [0] ,
and press the buttons,
[Input] , [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds.
If doesn’t beep, repeat from the beginning.
This mode maintains until you turn off the main power switch.
Projector Setup