6
(3) Press [R], [G] or [B] key to select the adjustment.
When you press the key, it turns ON or OFF. For
example, to display red, press [G] and [B].
R-Burst
B-Burst
G-Burst
4. LCD panel drive center voltage
adjustment
(Perform the
adjustment when replacing main PC
board or LCD panel)
When inputting video signal data to the LCD panel,
center voltage of specified range is adjusted to output
symmetrical wave.
If this voltage is out of alignment, the LCD panel is
damaged by flicker or burning. So it must adjust
completely.
R, G and B panels should be adjusted for each front
projection mode (Front) and Ceiling hunger projection
mode (Ceiling).
(1) Start signal generate software (SINGO98.exe)
and select the Burst signal to output.
(2) Right-click to display the Burst submenu, enter
[1] in the line interval box and select [V] in the H/
V.
