Toshiba STRATA CIX, Programming Manual

Page: 155 / 248

Unified Messaging (UM)
Server Installation
Strata CIX Voice Mail Programming 01/07
7-7
Uni
fie
d Me
ss
a
g
ing
(UM
)
Step 4: Configure User Mailboxes for UM
1. From the eManager Main menu, click Advanced Configuration > Voice Mail > Mailbox. The
Mailbox Editor screen displays.
2. Type the Mailbox number to be modified into the header of the screen and click Refresh.
3. Click Unified Messaging tab.
4. Check the Enable field.
5. Fill in remaining fields on the screen (see “Unified Messaging” on page 4-20 for an explanation
of all the fields.)
6. Configure additional mailboxes for UM as needed.
Step 5: Configure Voice Mail System Parameters
For UM to operate correctly, you must check the UM configuration parameter settings in the voice
mail system and modify their settings appropriately. See
“Modify Parameters” on page 3-30 for
instructions on modifying the settings for the Unified Messaging parameters shown in Table 7-1 .
Table 7-1 System Parameter Definitions
Parameter Description
sys_smtp_retry_count
Defines the maximum number of retries for sending voice messages to the E-
mail server.
Default: 5
sys_smtp_retry_delay
Number of milliseconds voice mail waits between retries for
sys_smtp_retry_count.
Default: 60 (milliseconds)
sys_smtpserver_gateway
Configures a dedicated SMTP Gateway server in SES. Enter the Gateway
server’s Name or IP Address and Port Number. (See
“SMTP Dedicated
Gateway Server” on page 7-13 .)
Example: PCName;9875
l
The server name and the port number should be separated with a blank,
a comma, or a semicolon.
l
Keep in mind that when you intend to use a custom TCP port for your
services, you should always pick a number greater than 1000.
l
You cannot use the default TCP port number of 25 for the Gateway
server if it resides in the same PC as the Stratagy ES (port 25 is being
used for Stratagy’s own SMTP server).
Default: blank
sys_smtpserver_host
Stratagy ES hosts its own internal SMTP server in order to support the UM
feature. SMTP servers require host names to identify them in an SMTP
transmission. This parameter defines the host name for the Stratagy ES
SMTP server.
The host name is used as a part of the source address of an UM message
sent to an e-mail server. For example, if the
sys_smtpserver_host parameter
is set to “stratagyes,” then an UM message from mailbox 200 would have a
source address of “200@stratagyes”.
In most cases using the computer name of the Stratagy ES server is
sufficient. However, Toshiba recommends that you confirm the appropriate
host name for the Stratagy ES SMTP server with your site System
Administrator.
Default: blank