Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 243 / 724

DK424i Configuration
Worksheet 2: Strata AirLink Wireless Telephone
Strata DK I&M 6/00
6-23
DK424i Configuration
Configuring Strata DK AirLink
You can configure Strata AirLink two ways:
♦ An external Base Station Interface Adapter (BSIA) interface unit that works with RSTU
PCBs.
♦ The RWIU plug-in PCB interface that does not require RSTU PCBs.
Important!
♦ If more than 16 AirLink Handsets are needed you must consider the cost of the RWIU as
compared to the cost of cabinets and system processor PCBs.
♦ Each RWIU PCB can support up to 16 AirLink Handsets with the BICU and B2CAU/B2CBU
processors.
♦ Each RWIU PCB can support up to 32 AirLink Handsets with the B3CAU/B3CBU and
B5CAU/B5CBU processors.
Strata AirLink Wireless Handset Configuration Guidelines with BSIA Interface
The wireless BSIA can support up to 32 wireless handsets.
1. Determine the number of wireless handsets needed that interface with BSIA and enter the
quantity in W01 in “Worksheet 2: Strata AirLink Wireless Telephone” on Page 6-22 and ST09
in “Worksheet 3: Standard Telephone” on Page 6-24 .
2. Refer to the Strata AirLink System Installation Guide to determine the number of BSIA
interfaces needed. The wireless Base Station Interface Adapter, BSIA, can support up to 32
wireless handsets.
3. Refer to the Strata AirLink System Installation Guide to determine the number of Base stations
required. Each BSIA can support up to two base stations and 32 handsets.
♦
BSIA needed – enter into W12
♦ Base Stations needed– enter into W09.
4. Refer to the Toshiba Price List, StrataLink section to configure optional parts.
Strata AirLink Wireless Handset Configuration Guidelines with RWIU Interface
The RWIU circuit card can support up to 16 or 32 wireless handsets depending on the placement
(cabinet/slot) of the RWIU.
1. Determine the number of wireless handsets needed that interface with RWIU and enter the
quantity in W03
2. After the number of wireless handsets are needed determine the quantity of RWIU PCBs and
cabinet slots are needed – see Table 6-21 on Page 6-31 in “Worksheet 6: DK424i Cabinet Slot
Configuration” on Page 6-27 .
♦ RWIU PCBs needed – enter into W04
♦ RWIU slots needed – enter into W05