Program 28 DSS Console/Attendant Telephone Assignments
System & Station
Strata DK40 Programming Manual Spring 1999
3-51
Program 28
DSS Console/Attendant Telephone Assignments
Program Type:
Station
Initialised Default:
Assigns Console #1 to Attendant Telephone #1;
Console #2 to Attendant Telephone #2; etc.
Program 28 Overview
DK40: allows up to three DSS consoles (DK40 KSU supports one DSS, dependent
on the system configuration the Expansion Unit can support up to two more). A
DDSS console can only be connected to circuit 8 of the DK40 base digital ports or a
PDKU, and an HDSS console can only be connected to circuits 7 and 8 of a PEKU.
The telephone connected to circuit 1 of the PCB or the DK40 Base KSU supporting
a console is designated as an attendant telephone. Consoles and telephones are
numbered 1~3 as they are installed from the lowest to highest slot number. For
example, in Slot 11 if a console is connected to circuit 8 of the DK40 Base KSU, the
DDSS console would be Console #1 and the digital telephone connected to circuit 1
would be Attendant Telephone #1.
As many as three DSS consoles can be assigned to one attendant telephone. Because
more than one DSS console can be assigned to an attendant telephone, the detailed
arrangement must be programmed. Initialised data assigns one DSS console to one
attendant telephone, both connected to the same PDKU or PEKU PCB.
(QWHU 3URJ 0RGH
0
6SNU
5 ;
+ROG
0
6SNU
+ROG
0
6SNU
& &
+ROG
0
6SNU
& &
+ROG
Processor
DSS Consoles
HDSS Consoles
DK40
1~3
1~3
DDSS PDKU/HDSS PEKU PCBs
(Lowest to Highest)
DDSS/HDSS Console Number
Attendant DKT/EKT Number (1~3)
Low Slot Number:
1
Slot Number:
2
High Number:
3
SELECT = 1~3
Enter the DSS console number.
Digital DSS consoles (DDSS) should be assigned to
digital telephones, and electronic consoles (HDSS)
should be assigned to electronic telephones.
DSS ATT = 1~3
Enter the attendant digital or electronic telephone number.