Toshiba SD-340ESB, Owner'S Manual

Page: 18 / 64

19
Connections
Connecting to a TV (Using the component video jacks)
• Make the following setting.
On-screen display Select: Page
Digital Out
Video output
PCM or Raw
YUV
Switching the output signal (interlaced/
progressive) using the remote control
You can temporarily switch the output signal for better
picture quality.
Press PROGRESSIVE on the remote control during stop
mode.
Press PROGRESSIVE again to turn off progressive mode.
Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD
video player away from the tuner and radio.
• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, high volume sound may damage your hearing as well as the speakers.
• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power on, the
speakers may be damaged.
• Progressive can be on/off only when video output is set to YUV.
58
• When Progressive is on, only component video will be output.
• When the TV system is set to PAL mode, all output will be forced to PAL type (e.g. 625p, 625i, etc.).
58
• When the TV system is set to NTSC mode, all output will be forced to NTSC type (e.g. 525p, 525i, etc.).
58
• Analog audio out will not have sound if DTS playback is selected.
Interlaced outputs/inputs
Some TVs or monitors are equipped with component video inputs.
Connecting to these inputs allows you to enjoy higher quality picture
playback.
Actual labels for component video inputs may vary depending on the
TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)
In some TVs or monitors, the color levels of the playback picture may
be reduced slightly or the tint may change. In such a case, adjust the
TV or monitor for optimum performance.
Progressive outputs/inputs
Some TVs or monitors are equipped with component video inputs that
are capable of reproducing a progressively scanned video signal.
Connecting to these inputs allows you to view the highest quality
pictures with less flicker.
Consumers should note that not all high definition television sets are
fully compatible with this product and may cause artifacts to be
displayed in the picture. In case of 525 or 625 progressive scan
picture problems, it is recommended that the user switch the
connection to the “standard definition” output. If there are questions
regarding our TV set compatibility with this model 525p and 625p DVD
player, please contact our customer service center.
Audio cable
To audio
input
To Y video input
To P
B
video
input
To P
R
video
input
To 2ch AUDIO OUT
(R: red, L:white)
54
54
59
58