Additional memory module is a precision electronic component that
may be fatally damaged by static electricity. Since the human body
can carry static electricity, it is important that you discharge yourself
before touching or installing any additional memory modules. To
discharge your body’s static electricity, simply touch any metal close to
you with bare hands.
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.
Installing a memory module
To install a memory module, follow the steps as detailed below:
1.
Shut down the computer - make sure the
Power
indicator is off (refer
to the
section in Chapter 1, Getting Started if
required).
2.
Remove the AC adaptor and all cables and peripherals connected to
the computer.
3.
Close the display panel.
4.
Turn the computer upside down and remove the battery pack (refer to
section in Chapter 5, Power and Power-Up
Modes, if required).
5.
Loosen the screw(s) securing the memory module cover in place -
please note that the screw(s) are attached to the cover in order to
prevent them from being lost.
Use a point size 0 Phillips screwdriver.
Satellite L730/L735/Satellite Pro L730
User's Manual
3-34
