E6581277
c
- 7 -
2. Names and functions of main parts
The drawings below show names and functions of main parts.
Front view
8 ( ( 8
COPY
MODE
RUN
PRG
MON
EASY
Hz
%
RUN
A
STOP
B
MODE
ESC
ENT
EASY
Hz lamp
*1
Lights when displayed
values are Hz.
% lamp
*1
Lights when displayed
values are %.
Operation keys
In “REMOTE KEYPAD MODE”, the key functions are the same as that of
the inverter. See the inverter instruction manual.
In “COPY MODE”, refer to the next page about the key functions.
MON lamp
Lights when the inverter
is in monitor mode.
PRG lamp
Lights when the inverter is
in parameter
setting mode.
RUN lamp
Lights when an ON
command is issued but
no frequency signal is
sent out. It blinks when
operation is started.
“COPY MODE” lamp
Lights when the Remote
Keypad is in
“
COPY MODE”
RUN key lamp
Lights when RUN key
is enabled.
Up/Down key lamp
Frequency setting by
up/down keys are enabled
while this lamp is lit.
EASY lamp
*2
Lights when the inverter
is in EASY mode.
Potentiometer lamp
*3
Lights when the
potentiometer is enabled.
Potentiometer
*3
Operation frequency can
be changed when the
built-in potentiometer
lamp is lit
SFT
C
Display
Displays setting,
device status, trip
information, etc.
Reverse view
Communication
connector
Connect
communication
cable
Seal material
Seal material for
installation.
Communication
Mode Switch
Select communication
mode
RS485:
VF-AS1, etc.
LOGIC:
VF-S11,VF-nC1,
VF-A7, etc.
Screw hole
For mounting
screws
R
S
485
LOGI
C
Screw hole
For mounting
screws
*1: These lamps are not lit when Remote Keypad is connected to VF-S11, VF-nC1, VF-S9, VF-A7, VF-P7 etc.
*2: The lamp is not lit when Remote Keypad is connected to an inverter without [EASY] key.
