Toshiba Q9 Series, Installation And Operation Manual, Page: 72 / 233

62 Q9 ASD Installation and Operation Manual
Type Reset
Program

Utility Group
This feature assists the user when performing fault analysis or by allowing a quick
system setup change when required. Performing a Type Reset results in one of the
following user-selected post-reset configurations.
Settings:
0 — None
1 — 50 Hz Setting
2 — 60 Hz Setting
3 — Reset to Factory Settings
4 — Clear Past Trips
5 — Clear Run Timer
6 — Initialize Typeform
7 — Save User Settings
8 — Restore User Settings
9 — Clear Cumulative Fan Timer
10 — Accel/Decel Time Setting 0.01 – 600.0 Seconds
11 — Accel/Decel Time Setting 0.1 – 6000.0 Seconds
Direct Access Number — F007
Parameter Type — Selection List
Factory Default — None
Changeable During Run — No
Forward/Reverse Run Selection
No Path — Direct Access Only
While operating using the keypad ( F003 is set to Panel Keypad) this parameter
sets the direction of motor rotation. This setting may be changed during operation.
This setting will not override parameter
F311 (Forward/Reverse Disable).
If either direction is disabled via parameter F311 , the disabled direction will not
be recognized if commanded by the keypad. If both directions are disabled via
parameter
F311 , the direction command from the keypad will determine the
direction of the motor rotation.
Settings:
0 — Forward
1 — Reverse
2 — Forward (EOI-Switchable F/R)
3 — Reverse (EOI-Switchable F/R)
Direct Access Number — F008
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — Yes
Reset
F007 F008