SMMS High-Wall Type
Owner’s Manual
– 11 –
Toshiba
8
HOW TO USE REMOTE CONTROLLER
Cooling/heating/fan only
operation
Start
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
, Heat
, or Fan only
.
3
Temperature button (
)
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
LOW
, LOW
+
,
MED
, MED
+
,
HIGH
.
• The
OPERATION lamp (green) on the
display panel of the indoor unit goes on. And
operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The
: Fan only mode does not control
temperature.
• Fan speed
is the same as
HIGH
.
Therefore, perform only steps
1
,
2
and
4
to
select this mode.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with a
cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
Dry operation
Start
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY
.
3
Temperature button ( )
Set the desired temperature.
• The fan speed display indicates
• The
OPERATION lamp (green) on the
display panel of the indoor unit lights, and
operation starts after approximately 3 minutes.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
PRESET
MODE
TEMP
FAN
2
4
3
1
TEMP
PRESET
MODE
TEMP
FAN
2
3
1
TEMP
11-EN
+1111050401_11L_SMMS_HighWall_OM_B5_print_ONLY.book Page 11 Friday, November 21, 2008 4:47 PM
Summary of Contents for MMK-AP0073H
Page 266: ...1111050401 ...
