– 49 –
Arranging the to back air intake type
<Back air intake>
Filter cleaning sign term setting
The lighting term setup of the filter sign (Notification of filter cleaning) of the remote controller can be changed
according to the condition of installation.
For setup method, refer to “Filter sign setting” in the Applicable controls of this Manual.
Remove the cover plate and
then fix it to the bottom
surface.
Do surely hooking to the
main unit.
Main unit
(after remover)
Air filter
Main unit
Air filter
Force
Remove the filter from the main unit while pushing
down on the tabs.
4
Installation
CAUTION
Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not put a heavy article on the indoor unit or let a person get on it. (Even units are packaged)
• Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, use buffering
cloth or other material to not damage the unit.
• To move the indoor unit, hold the hooking brackets (4 positions) only.
Do not apply force to the other parts (refrigerant pipe, drain pan, foamed parts, resin parts or other parts).
• Hanging bolt pitch of air intake chamber side is different (centre position), make sure not to make mistake to install
the setting direction.
• Carry the package by two or more persons, and do not bundle it with plastic band at positions other than specified.
External dimensions
(Unit: mm)
803 (inside)
Refrigerant piping
845
805
910
Air filter
Fresh air intake
(knock-out hole)
Hung-up plate
Drain-up port
33
4-
Ø4
16
8
(i
ns
id
e)
21
0
57
67
51
1
67
645
80
16
8
12
0
21
80
59
103
21
20
40
35
9
37
2 42
2
50
2
19
21
21
163
Ø92
31
97-EN
98-EN
+00EH99886701-2_01EN.book Page 49 Wednesday, August 19, 2015 11:27 AM
