23
Select one of the followings according to your connection, and press OK.
5.1ch
When a 5.1 channel surround system is connected to this player.
1 Set the speaker sizes, distance to each speaker and the crossover frequency.
Front Left / Front Right
Small: Select if the speaker cannot output low frequency.
Large: Select if the speaker can output low frequency.
Center / L Surround / R Surround
Small: Select if the speaker cannot output low frequency.
Large: Select if the speaker can output low frequency.
None: When the speaker is not connected.
Subwoofer
Use: When a subwoofer is connected.
Don’t Use: When a subwoofer is not connected.
Crossover Setting
Low frequency under this frequency (80Hz / 100Hz / 120Hz) will
be output to a connected subwoofer.
m
Select a distance to each speaker from the listening position.
2 Select “Next”, then press OK.
To cancel to return to the previous screen, select “Clear”, then press OK.
To save your selection and fi nish the setting, select “End”, then press OK.
3 Select “Automatic Test Tone”, then press OK.
A test signal is set to each speaker.
4 Adjust each of the volumes by / , selecting
speakers by / so that each speaker can
sound at the same volume.
For further adjustment, check the channel balance
on the amplifi er.
5 When complete, select “End”, then press OK.
Note
• This setting is effective only when “Digital Out SPDIF”
(
page 22) is set to “PCM”.
2ch
When a 2ch stereo system is connected to this player.
Large
Front Left
0.00 ft
Front Left
0.00
ft
e.g.
Large
17
Press RETURN or to return to the menu of step 1.
When you connected an audio system to the ANALOG AUDIO OUTPUT jacks (
page 16, 17):
Press / to select “Speaker Setting”, then press OK.
CH
3PEAKER3ETTING
CH
&RONT,EFT
D"
#ENTER
&RONT2IGHT
D"
EG
D"
(Continued)
HD-EP35KE̲Eng.indd 23
HD-EP35KE̲Eng.indd 23
07.8.30 7:34:45 PM
07.8.30 7:34:45 PM
