Toshiba GX7R ASD, Quick Start Manual, Page: 44 / 85

36 GX7R ASD Quick Start Guide
Panel Menu
The Panel menu is accessed by pressing ESC from the Frequency Command screen. The control settings
of the Panel menu are effective for EOI control only.
The Panel menu provides quick access to the following menu parameters:
Direction — Forward or Reverse .
Stop Pattern
— The Decel Stop or Coast Stop selection determines the method used to stop the
motor when using the Stop|Reset key of the EOI. The Decel Stop setting enables the Dynamic
Braking system setup at F304 or the DC Injection Braking system setup at F250 , F251 , and F252 .
The Coast Stop setting allows the motor to stop at the rate allowed by the inertia of the load.
Note: Dynamic Braking is not used with the GX7R ASD.
Note: The Stop Pattern setting has no effect on the Emergency Off settings of F603 .
V/f Group
— One of four V/f profiles may be selected and run. Each V/f profile is comprised of four
user settings: Base Frequency , Base Frequency Voltage , Manual Torque Boost , and Electronic
Thermal Protection . Expanded descriptions of these parameters may be found in the GX7R ASD
Install and Op Manual .
Accel/Decel Group — One of four Accel/Decel profiles may be selected and run. Each of the
Accel/Decel profiles is comprised of three user settings: Acceleration , Deceleration , and Pattern .
Expanded descriptions of these parameters may be found in the GX7R ASD Install and Op Manual .
Feedback in Panel Mode — This feature enables or disables the PID feedback function.
Torque Limit Group — This parameter is used to select one of four preset positive torque limits to
apply to the active motor (of a multiple motor configuration). The settings of profiles 1 – 4 may be
setup at
F441 , F444 , F446 , and F448 , respectively.