INSTALLATION
Installation
Avoid any humid or wet place, for example, the neighborhood
of a kitchen sink. Such a place could cause corrosion or
electric leakage in the refrigerator. If installed directly on the
ground, your refrigerator will be liable to damage. Place a
board under the machine in such a case.
Keep the refrigerator away from the sunlight, a gas range
or heater.
Placed in the sunlight or near a heat emitting object, the
refrigerator will have its cooling effect reduced and a failure
might be occured.
Leave space around the refrigerator.
Select a well-ventilated place. Provide at least 30 cm(12 inches)
at top,10 cm(4 inches) at rear side and 5 cm(2 inches) on the
left and right of the refrigerator for proper air circulation.
When you open the door of the refrigerator, there may be
a smell of plastics. This signifies nothing unusual.
Switching off your refrigerator when not using.
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
at least 5 cm
INFORMATION
•
Heat Generation by the Compressor
The refrigerator compressor will generate heat during normal
operation. Note that this is not a malfunction.
•
Heat on Refrigerator Walls
The condenser is built on the outer shell and radiates heat
into the room air. The temperature of the outer shell may
reach high temperature during normal refrigerator operation.
This is not a malfunction.
•
Refrigerator Operation
When the power is first turned on or ambient temperature
becomes high, it may happen that the refrigerator surface
getting warm or noise from the compressor.
When the refrigerator enters stable state, it will run normally.
Be careful before moving or installation.
If you have moving or installation, maybe impact
around PCB Box at rear side which have a damage
to refrigerator.
-7-
Installation position for refrigerator.
-
-
5 cm
10 cm
at least 10 cm
30 cm
•
•
•
移动或安装前请小心。
PCB
Up
Down
Leg
30 cm
12
10 cm 4
5 cm 2
适当的空
Install your refrigerator on a strong and level floor. Turn the
adjustable leg and stabilize the refrigerator horizontally.
- Adjustable leg right side can be adjust up and
down.
- Turn adjustable leg clockwise to raise each side
of the refrigerator, or turn counter clockwise
lower it.
at least 30 cm
PCB Box
PCB
Summary of Contents for GR-A25HSZ
Page 12: ...EMQD B ...
