Toshiba GR 200 Series, Instruction Manual

Page: 832 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 811 -
4.9.3
Operate logic for SBO/DIR modes
After the completion of the operation of the select logic, the operate logic starts to control the
device.
(i)
Receiving “Operate command for P1-control” from the remote-end
Figure 4.9-26 depicts the reception of the operate command ‘P1-control’ from the remote-end.
Signal reception in
IEC61850
P1 control from the remote-end
Do nothing
Operation
decision
Success
Failed
Operate logic
P2 control from the remote-end
P3 control from the remote-end
P1 control from the local-end
P2 control from the local-end
P1 control by the PLC function
P3 control from the local-end
P2 control by the PLC function
Wait for a command
P1 control from the remote-end
P3 control by the PLC function
Select stage
Signal output
P1 control from the local-end
P2 control from the local-end
P2 control from the remote-end
P3 control from the remote-end
P3 control from the local-end
P1 control by the PLC function
P2 control by the PLC function
P3 control by the PLC function
Wait for a next command
Figure 4.9-26 Outline of operate command ‘P1-control’
Mapping required for Input point
Figure 4.9-27 illustrates the operate logic when a “Operate command P1 (Remote-P1-Control)”
signal is applied to the TPOS01 function. The input-point “DEV01_CONTROL_REQ” is used
for the reception of the “Operate command P1 (Remote-P1-Control)”.