Toshiba GR 200 Series, Instruction Manual

Page: 741 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 720 -
DPOS01 function (Function ID:
512001)
DPOS01_OSL_BO_CSF
”
(512001 _ 8603011DC6)
DEV01_CONTROL_REQ
Command
“Remote-On-Control”
ILK
†
condition (“ON”) passed
Either
“SBO mode” or “DIR mode”
(e.g.,
“ctlmodel” in IEC61850 *
)
In SBO operate
In DIR operate
Select
“Failed”
512001 _ 7003016D08
DPOS01-Close
To BO connection
Input Output Select logic in DPOS01
0.1s
0
t
0.6s
0
t
& &
&
&
&
Select on
“Success”
“Automatic sequence control function (AQEQ)
§
” in progress
ASEQ_MULTI_SEL
Select condition
‡
1
≥
Select command
with ILK
†
condition
Operate command
with ILK
†
condition
Select command
without ILK
†
condition
Operate command
without ILK
†
condition
For SBO operation
For DIR operation
To
“Wait for a command”
For DIR operation
For SBO operation
To
“Wait for a next
command
”
Figure 4.8-2 Select ‘On’ from the remote-end in DPOS01 ††
†Note: The software interlocking (ILK) function provides the operation criteria for “On”.
The ILK function is discussed separately; note that the operation criteria is
defined by the ILK function itself (i.e., the user cannot set the condition).
‡Note: A “select condition” signal is provided from the select condition scheme. For more
information, see Figure 4.8-13.
§Note: An automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The DPOS01 operation is blocked for the ASEQ function being
in operation. For more information of the ASEQ function, see Chapter
Control and
monitoring application: Automatic sequence control function.
*Note: The DPOS01 function can run in either the “SBO mode” or the “DIR mode” using
a signal called “ctlmodel” when communication is implemented using IEC61850.
To use this signal, the user must map it for IEC61850 communication.
††
Note: To identify the input and output points of the other DPOS logics, see Table 4.8-5
and Table 4.8-9.