Toshiba FT-8009, Service Manual

Page: 18 / 45

19
7. The voice of the caller cannot be heard (incoming call).
Can the base and handset be
connected? See 3. The base and handset
cannot be connected.
OK
NG
The 1 kHz, 77.5mV sine
waveform is applied to TEL-
line of the base, can the 1 kHz
sine waveform from the Q3
collector be fed? Check the base TEL-line
circuit and REPLAY control
circuit.
NG
Check whether there is the
1 kHz sine wavefor m at
pin 24 of IC1. Check Q4 and its peripheral
circuit. NG
OK
OK
Check whether there is the
1 kHz sine wavefor m at
pin 20 of IC1. Check IC1 and its peripheral
circuit. NG
OK
TX output signal from the
base is detected by the liner
detector, can the 1 kHz sine
waveform be fed?
Check base RF unit.
NG
OK
Check whether there is the
1 kHz sine waveform at pin 9
of IC401 on the handset unit. Check IC401, Q401 and
their peripheral circuit. NG
OK
Check whether there is the
1 kHz sine waveform at pin 3
of IC403. Check RT402, Q402 and
their peripheral circuits. NG
OK
Check whether there is the
1 kHz sine waveform at the
pin 18 of IC403. Check IC403 and its
peripheral circuit. NG
OK
Check whether there is the
1 kHz sine waveform at pin
1, 2 of SP801. Check Q405, Q406 and its
peripheral circuit. NG
OK
Check SP801 and W801,
W802.
Check handset RF unit.
NG
OK
Check whether there is the
1 kHz sine wavefor m at
“MOD” RF unit. Check RT3 and its
peripheral circuit. NG
OK