Toshiba e-studio 2555c, Service Manual

Page: 777 / 1558

8
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8 - 221
[F102] HDD start error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] HDD other error
[F106_0] ADI-HDD error: Illegal disk replacement detected (ADI-HDD Exchange to SATA-HDD)
Classification Contents
Other service call HDD start error: HDD cannot become “Ready” state.
HDD transfer time-out: Reading/writing cannot be performed in
the specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
Check item Measures
HDD • Connector and harness check
• Check if the connector pins of the HDD are bent.
• Perform the bad sector check (08-9072). If the check
result is OK, recover the data in the HDD. If the check
result is failed, replace the HDD.
Replacement part Measure
HDD
SYS board
Classification Error item
Other service call
ADI-HDD error: The ADI-HDD has been replaced illegally to
SATA-HDD (normal type).
Check item Measures
Setting Check if the HDD has been replaced with a SATA-HDD
(normal type).
1. Start the equipment in the 4C mode: [4] + [C] +
[POWER]
2. Check the type of the HDD shown on the top left of the
control panel display "Current HDD type".
2a. In case of "SATA-HDD" (normal type), replace it with
the original ADI-HDD or a new ADI-HDD.
Notes:
To replace with the original ADI-HDD, start the
equipment in the normal mode and then reinstall
system software only if any abnormality occurs.
2b. In case of "ADI-HDD"
Check each item in the Measures field for the HDD
below.
If the error still occurs, reinstall the system software.
HDD • Connector check
• Harness check
Follow the procedure below if no abnormality is found in the
check items above.
1. Start the equipment in the 4C mode: [4] + [C] +
[POWER] -> 1. Revert factory initial status HDD
2. Reinstall the system software.