Toshiba Carrier RAS-09EA Series, Service Manual

Page: 18 / 49

– 18 –
8-3. Names and Functions of Indicators
on Remote Controller
(a) Transmission indicator
• This transmission indicator lights when remote
controller transmits signals to the indoor unit.
(b) ON/OFF display
• Displayed by pushing the START/STOP but-
ton.
• Push the START/STOP button again to dis-
appear.
(c) MODE display
• Displays the current operation mode.
(d) TEMP> display
• Displays the temperature setting
(17°C to 30°C)
• When you set the operating mode to FAN
ONLY, no temperature setting is displayed.
(e) ECONO. display
• Displayed by pushing the ECONO. button.
• Push the ECONO. button again to disappear.
(f) FAN speed display
• Displays the selected fan speed. AUTO and
three fan speed levels “LOW”, “MED”, “HIGH”
can be indicated.
• Displays AUTO when the operating mode is
either AUTO or DRY.
(g) TIMER display
The time set for timer operation is indicated.
Note:
• In Fig. 8-4, all displays are indicated for the sake
of clarity. During operation, only the relevant dis-
plays will be shown on the remote controller.
Fig. 8-4
8-4. Handling the Remote Controller
8-4-1. Location of the Remote Controller
Keep the remote controller where its signals can reach
the receiver of the air conditioner (a distance of 7m is
allowed.)
Fig. 8-5
8-4-2. Remote Controller Mounting Fixture
A mounting fixture for the remote controller is sup-
plied with it.
(1) Installing the mounting fixture
Before you actually install the mounting fixture
on a wall or the pillar, check whether the remote
control unit signals from the location where you
will install the fixture can be received by the in-
door unit.
Fig. 8-6
(2) Mounting and removing the remote controller
To mount, hold the remote controller parallel to
the mounting fixture and push it in fully. To re-
move, slide the remote controller upwards and
out from the mounting fixture.
Fig. 8-7
MODE
FAN
AUTO
COOL
DRY
FANONLY
AUTO
LOW
MED.
HIGH
TEMP.
Hr.ON OFF TIMER
(c)
( g )
(e) (a) (d)
(b)
( f )
7m