27
MAINTENANCE
L
How to remove
Hold the upper side of the cassette filter, and push down
and pull it at the same time.
Clean the lint trap at the end of operation.
Cassette filter
When it is difficult to remove the filter case due to lint
attached, wet it with water to soften the lint.
L
How to set in
Hold the filter case with its top side up. Put the lower side
of the filter case in the filter stand, and then push it until a
“click” sound is heard.
L
How to set in
1
Set the filter case to the filter cover as follows.
2
Press down the filter cover case until a “click” sound
is heard.
L
When the filter valve inside the filter cover is
loosened
If the filter valve is loosened, lint may not be collected.
1
Set the filter valve to the filter case while aligning its
concavity and convexity to those of the filter case.
Filter slot
Cassette filter
Filter slot
Cassette filter
Filter cover
Filter cover
Filter case
Filter cover
Filter case
Filter valve
Concavity
Filter cover
Convexity
2
Insert the groove of the filter valve to the click at the
center of the filter cover.
Click
Groove
CASSETTE FILTER
L
How to remove
Turn over the filter, and then slide the filter case in the arrow
direction of the following figure (
1
) to remove it (
2
).
Clean inside the filter cover and the filter case.
Wipe or Wash out any remaining detergent.
If there is any remaining detergent hard to be removed, use the “TUB CLEAN” course.
•
Before put detergent or breach to in the detergent/breach dispenser, remove water in its inlet.
With any remaining water, detergent may be hardened and attached.
DETERGENT/BREACH DISPENSER
Detergent/Softener case
Remove the case to clean it. In addition, wipe away any dirt from the water supply port.
Removing the case
1
Removal procedure;
Pull the detergent /softener case toward you, then lift it for removal.
2
Remove the cap of the detergent/softener case.
Make sure to put back the cap after removing the
cap. If the washing machine operates without the
cap in place, the softener does not enter.
Remounting procedure
1
Mount the cap of the insertion case
2
Lift the case obliquely in the same way as you remove
it, and insert it deeply along the guides.
Guides
Cap
Filter case
