12
MAINTENANCE
Lint collector
Clean the lint collector after every use.
How to remove
Insert fingers deeply into the recess. By strongly
holding down the collector, pull it toward you.
How to replace
Check the top and bottom of the collector. Then mount the bottom. Hold down the recess, press the collector
against the collector mounting base until the shaft fits into position.
•
In the event that the net is damaged, consult your
nearest dealer.
Softener case
Remove and clean after every ten usages.
Removal
1
Hold down the each.
2
And pull toward you.
Installation
1
Fit in the bottom.
2
Then press in the top until the
catch catches.
Caution
•
Water in the case may freeze in cold weather.
If this occurs, remove the case, immerse in warm water (less than 40°C) for 10 minutes, and replace after dried well.
Softener case
Catch
12/12/06, 9:55
12
Detergent case
Remove the case to clean it. In addition, wipe away any dirt from the water supply port.
Removing the case
Removal procedure;
Pull the detergent
case
toward you, then lift it
for removal.
Remounting procedure
Lift the case obliquely in the same way as you remove
it, and insert it deeply along the guides.
Guides
