Copyright 2013
All Rights Reserved
Page
2
of
2
4
Plug the TV back into AC power.
5
The Software upgrading process will begin.
During the Software upgrade, the TV receiver will display
“Software upgrade in progress” as shown
in Figure3.
Figure3
The progress bar will be proceed after 3 minutes
IMPORTANT:
DO NOT unplug the AC power from the TV or press any buttons on the remote controller or
the TV keypad during this process.
6
Upon completion of the Software upgrade a massage will appear as shown in Figure4.
Figure4
7
Momentarily remove (~10 seconds) AC power from set by unplugging the AC power cord.
Remove the USB drive from the slot.
Plug the TV back into AC power. The TV should turn back on after 2 minutes.
8
Please follow the instructions on the screen to setup the TV according to your needs
(including channel setup).
1%
Please wait …
DO NOT unplug your TV!
Software upgrade in progress.
making your TV inoperable.
Doing so may corrupt the system
100%
The software upgrade is complete
Your TV system will reboot
after which you may
resume normal viewing.
