Toshiba 32ZP46P, Service Manual

Page: 11 / 59

– 11 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
ITEM ADJUSTMENT PROCEDURE
1. Call up the adjustment mode display, then select the item WID .
2. Press the
;
– /+ button to get the picture so the left and rightedges of raster
begins to lack.
3. Press the
;
– /+ button to advance the data by 7 steps.
Note : Check the horizontal picture position is correct.
1. Call up the adjustment mode display, then select the item PARA .
2. Press the
a
button on Remote until the cross-hatch pattern appears on the screen.
3. Press the
;
– /+ button to make vertical lines straight as shown below.
WIDTH
(WID)
E-W PARABOLA
(PARA)
WHITE BALANCE
ADJUSTMENT
•
CUTOFF ADJUSTMENT
(RCUT)
(GCUT)
(BCUT)
•
DRIVE ADJUSTMENT
(GDRV)
(BDRV)
1. Set Contrast to 40, and brightness to +20 by picture control.
2. Receive the Black and White pattern.
3. Select RCUT, GCUT and BCUT with CHANNEL
s
,
t
buttons, to set individual
values to Initial reference data, and to set GDRV and BDRV to Initial reference
data with VOLUME
;
– /+ buttons (See page 18).
4. Press -/- - button on the remote control and rotate Screen VR to get one slight
horizontal line on screen.
Note: Every pressing of -/- - button provides Horizontal line picture and Normal
picture alternately.
5. Press -/- - button to release horizontal line picture, and select the two other colors
which did not light in the above step with CHANNEL
s
,
t
buttons. Then tap VOL-
UME
;
– /+ buttons so that three colors slightly light in the same level.
X
To correct white balance in light area,
select GDRV and BDRV with CHANNEL
s
,
t
buttons to adjust.
X
To correct white balance in dark area,
perform fine adjustment of RCUT, GCUT
and BCUT.
Light area check
(to show white)
Dark area check
(to show black)