ELECTRICAL ADJUSTMENTS
2-17: OSD H POSITION
1.
2.
3.
4.
5.
Receive the monoscope pattern from the Pattern
Generator.
Press the PIC SIZE button on the remote control to
select the FULL screen mode.
Using the remote control, set the brightness and
contrast to normal position.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (00) on the remote control to
select "OSD H".
Press the VOL. UP/DOWN button on the remote control
until the difference of A and B becomes minimum.
(Refer to Fig. 2-5)
Fig. 2-5
TV-A
00 OSD H
FULL
1
A
B
D-5
2-18: TILT CENT
1.
2.
3.
4.
5.
6.
Connect the digital voltmeter between CP403.
Receive the crosshatch signal from the Pattern Generator.
Press the PIC SIZE button on the remote control to select
the FULL screen mode.
Using the remote control, set the brightness and contrast
to normal position.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (46) on the remote control to
select "TILT CENT".
Press the VOL. UP/DOWN button on the remote control
until the voltage become minimum(0V).
2-16: COR TOP/BTM
1.
2.
3.
4.
5.
6.
7.
Receive the crosshatch signal from the Pattern Generator.
Press the PIC SIZE button on the remote control to select
the FULL screen mode.
Using the remote control, set the brightness and contrast
to normal position.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (19) on the remote control to
select “COR. TOP”.
Press the VOL. UP/DOWN button on the remote control
until the both ends vertical lines become straight.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (20) on the remote control to
select “COR. BTM”.
Press the VOL. UP/DOWN button on the remote control
until the both ends vertical lines of the screen become
parallel.
