Toshiba 3000 series, Operation Manual

Page: 28 / 126

14
model 3000 Ethernet Module / DS Connection Module Operation Manual
Chapter 3 Setting
3
3.1 Switch Setting
Before installing EN7 modules in the base unit, set the switches which determine an EN7
module operation mode and host ID. These switches are inside the EN7 module.
The switch setting procedures are described below. Figure 3-3 and Figure 3-4 shows the
locations of the switches.
3.1.1 Switch Setting Procedures
The EN711, EN721, EN731, EN741 module has the switches inside, so the switch cover
on the right side panel (see figure 3-1) must be removed before setting these switches.
To set the switches, follow the steps in the following sequence.
(1) Remove the screw from the right side panel (using a cross-head screwdriver). Make
sure that the screwdriver fits the slot in the screw head. Use of an unfit screwdriver
may deform the slot in the screw head.
(2) Remove the switch cover from the product.
(3) Set the switches. Carefully read the section 3.2 Network Parameter Setting.
(4) Place the removed switch cover back on the product.
Fasten the cover with the screw, using a screwdriver that fits the screw as when
removing it. Be careful not to overtighten the screw. Overtightening may damage the
screw threads, causing the screw to turn freely. The switches on the EN751,
EN751A, EN761, and FN711 are on the front panel.
Figure 3-1 Switch Setting Method ( EN711, EN721, EN731, EN741)
A
B
CDE
F
0
1
2
3
45 67
8
9
A
B
CDE F
0
1
2
3
45 67
8
9
off
1
2
3
4
5
6
7
8
Operation mode
setting switches
Host ID setting
seitches
Front of EN7 module
Screw
Swich cover