Toshiba 28 Series, Owner'S Manual, Page: 19 / 20

OK : To store
MENU : To return
EXIT : To exit
Manual setting
Colour : AUTO
EXT1 A VCR
19
Below are the answers to some of the most common queries.
For more information go to
www.toshiba.co.uk
A
Check the mains switch is on and check all
connections.
Check the television is not in standby mode.
Why is there no sound or picture?
Q
A
Check the SCART lead connection.
Why is there a good video picture but no sound?
Q
A
Make sure the VCR or DVD player is connected to
the television as shown on page 6, then select the
correct input by pressing
B
.
Why doesn’t the video/DVD being played show
on screen?
Q
?
For television
operation queries,
please ring the
helpline…
Remember…
A
Check the volume has not been turned down or
that sound mute has not been selected.
Why is there a picture but no sound?
Q
A
Interference or a weak signal. Try a different
television station.
Manual fine tuning may help.
What else can cause a poor picture?
Q
A
Check the batteries aren’t dead or inserted
incorrectly.
Why doesn’t the remote control work?
Q
A
Switch the television off and wait for the red led to
extinguish before switching back on. If the problem
persists contact the Helpline.
Where there is loss of colour, picture or the
position moves, how can this be restored?
Q
A
Check that Panel Lock is not ON .
Why don’t the controls on the front of the
television work?
Q
A
Remove it by pressing CALL .
Why is there a message permanently on the
screen?
Q
A
Check the correct input has been chosen,
S-VIDEO or Video . See AV connections .
Why is the VCR/DVD picture in black and
white?
Q
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the Text is unreadable or garbled, check the aerial.
Go to the
main index page of the teletext service and look
for the User Guide . This will explain the basic operation of
teletext in some detail. If further information is needed on
how to use text
see the teletext section.
Why are there problems with teletext?
Q
Q
uestions
and
A
nswers
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be achieved. The
colour is factory set to
AUTO to automatically display the
best colour system.
To check that you have the best colour:
There is a picture, but why is there little or no
colour?
Q
Select Colour from the Manual setting menu .
With
S
or
R
choose between AUTO, PAL,
SECAM, NTSC 4. 43 or 3. 58 .
1
2