53
Setting up your TV
Auto Tuning
v
You must set up the ANT/CABLE input source before
programming channels. See
v
The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
v
To tune the TV to a channel not programmed in the channel
memory, you must use the
Channel Number
buttons on the
remote control.
v
Programming channels when the
ANT/CABLE
input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have not already
done so, see
2
Press the
MENU
button and open the
Installation
menu.
3
Highlight
Channel Tuning
, and then press the
ENTER
button.
Turning
(Sample Image) Setup menu - Installation selection
4
Highlight
Auto Tuning
, and then press the
ENTER
button to
open the
Channel Program menu
to begin channel
programming.
Cable
Scanning channels, please wait...
Number of Channels Found - 7
Scanning Analog Channels
6%
Channel - 9
Cancel
!
(Sample Image) Installation menu - Channel selection
