DISASSEMBLY INSTRUCTIONS
B1-2
Fig. 1-7
Fig. 1-6
Shield MPEG
DVD PCB
Shield FFC
1
CP3803
CP4203
1-7: SCALER PCB (Refer to Fig. 1-7)
1.
2.
3.
4.
5.
6.
Disconnect the following connectors:
(CP202, CP204, CP801, CP3804 and CP7201).
Remove the 2 screws
1
.
Remove the Shield Scaler in the direction of arrow (A).
Remove the 2 screws
2
.
Remove the 2 screws
3
.
Remove the Scaler PCB in the direction of arrow (B).
1-6: DVD PCB (Refer to Fig. 1-6)
1.
2.
3.
Disconnect the following connectors:
(CP203, CP3803 and CP4203).
Remove the 4 screws
1
.
Remove the Shield FFC, Shield MPEG and DVD PCB in
the direction of arrow.
NOTE
Before your operation, please read “PREPARATION OF
SERVICING”.
Use the Lead Free solder.
Manual soldering conditions
• Soldering temperature: 350
±
5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD PCB connector.
1.
2.
3.
4.
5.
1-5: BACK LIGHT PCB (Refer to Fig. 1-5)
1.
2.
3.
Disconnect the following connectors:
(CP3802, CP7001, CP7002, CP7003 and CP7004).
Remove the 4 screws
1
.
Remove the Shield Inverter and Back Light PCB in the
direction of arrow.
Fig. 1-5
Back Light PCB
Shield Inverter
1
CP7003
1
1
1
CP7004
CP7002
CP7001
CP3802
1
1
1
CP203
Shield Scaler
Scaler PCB
2
CP202
(A)
(B)
1
1
3
3
2
CP204
CP7201
CP801
CP3804
