Toshiba 13P ASG -T, Installation Manual

Page: 12 / 28

OT R OT R
as ea est
emote Control A election
To separate using of remote control for eac indoor unit in case of 2 air
conditioner are installed near.
emote Control et .
1. Press RESET button on t e indoor unit to turn t e air conditioner ON.
2. Point t e remote control at t e indoor unit.
3. Pus and old CHEC button on t e Remote Control by t e tip of t e
pencil. 00 will be s own on t e display Picture
1
.
4. Press MODE during pus ing CHEC . B will s ow on t e display
and 00 will disappear and t e air conditioner will turn OFF. T e Remote
Control B is memori ed Picture
2
.
Note 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A ave not A display.
3. Default setting of Remote Control from factory is A.
C eck t e
fl
are nut connections for t e gas leak wit a gas leak detector
or soap water.
C eck places for
t e indoor unit.
C eck places for
t e outdoor unit.
W en two indoor units are installed in t e same room or ad acent two
rooms if operating a unit two units may receive t e remote control signal
simultaneously and operate. In t is case t e operation can be preserved
by setting eit er one remote control to B setting. Bot are set to A setting
in factory s ipment.
T e remote control signal is not received w en t e settings of indoor unit
and remote control are different.
T ere is no relation between A setting B setting and A room B room w en
connecting t e piping and cables.
est eration
To switc t e TEST RUN COOL mode press RESET button for
10 seconds. T e beeper will make a s ort beep.
A to estart ettin
T e product was s ipped wit Auto Restart function in t e off position.
Turn it on as re uired.
T is product is designed so t at after a power failure it can restart automatically
in t e same operating mode as before t e power failure.
In ormation
o to set the A to estart
1. Press and old t e RESET button on t e indoor unit for 3 seconds to
set t e operation. 3 beep sound and OPERATION lamp blink 5 time sec
for 5 seconds
2. Press and old t e RESET button on t e indoor unit for 3 seconds to
cancel t e operation. 3 beep sound but OPERATION lamp does not
blink
In case of ON timer or OFF timer are set AUTO RESTART
OPERATION does not activate.
10
OPERATION /
RESET Button