LDR1 & LDR6 Operating Manual – Rev 1
Tortuga Audio
Page: 9
evidenced by the rapidly flashing Status LED. The Balance can then be adjusted via
the Left and Right keys on the Remote. Once you’ve set the desired Balance,
pressing the Enter key will lock in the new Balance settings. Note that with the
Remote you can still raise and lower the Volume while the unit is in Balance Adjust
Mode.
The current Balance setting can be automatically reset (no left or right bias) by
pressing the Reset key on the Remote. Doing so will return the Balance settings to
zero as evidenced by the Status LED briefly pulsing and then remaining lit.
12 Volt Trigger
Output
When the unit is turned on, 12 volts DC will be present on the Trigger Output jack
on the lower right of the Rear Panel. This trigger signal can be used to turn on other
components equipped with 12 VDC trigger inputs; amplifiers being the most
common component. The Trigger Output will revert to 0 volts when the unit is
turned off.
The Trigger Output requires the use of a conventional 1/8
th
inch (3.5mm) mono
phone plug.
