NOTE
:
SWING ARMS HAVE SLIGHT BEND ON
EACH
END
. When
Swing Arms
are attached to
Main Frame
they
MUST
be in
CORRECT
position facing
AWAY
from main frame as shown in
Fig. 17 WHEN SCREWS ARE
TIGHTENED
.
Swing Arms
are shown
INCORRECTLY
attached in
Fig. 18
.
THREADS OF SCREWS MUST BE
ON OUTSIDE OF MAIN FRAME.
Place all
Swing Arms
onto
Main Frame
and
TIGHTEN
NUT UNTL RESIS-
TANCE IS FELT
.
Swing Arms
should move freely
BUT
have some resistance to their movement. Place protec-
tive
Acorn Nut
as shown in
Fig. 19
and tighten.
Fig. 17 CORRECT
Fig. 18 INCORRECT Fig. 19
Step 7
CAREFULLY
place
Seat and Back Chair assembly
into
Main Frame
as shown in
Fig. 20
.
Swing Arms
attach to bottom frame of
Seat and Back Chair assembly
. Arrange hardware as follows:
screw,
small washer, large washer, Swing Arm, large washer
as in
Fig. 21.
Slightly raise
Seat and Back Chair assembly
and push remaining threads of screw through mounting hole of
Seat and Back Chair assembly. Secure with
washers
and
nuts
. Tighten until resistance is felt.
Attach all
Swing Arms
in same fashion.
Fig. 20 Fig. 21
This completes Glider assembly.
