USER MANUAL: GT1300PSS
©
WWW.TORQFUSION.COM
16 OF 32
REV 1308
®
INSTALLING THE IMPACT SOCKET
Only impact sockets must be used with your torque tool. They must
be properly installed with locking pins and retainer ring. The output
drive of your tool may be either ¾” or 1” depending on how the
tool was ordered or what additional accessories were purchased
with it.
First slide the retainer ring (o-ring) over the socket as shown in
Figure 10.
Figure 10
- IMPACT SOCKET
Place the socket over the torque tool output drive (square drive)
aligning the locking pin hole with the hole in the output drive. Slide
in the locking pin (see Figure 11).
Figure 11
- SOCKET INSTALLATION
Finish the socket installation by rolling the retainer ring into the
socket groove to keep the locking pin in place.
Locking pin hole
Retainer ring
Locking pin
Socket groove