Toro Z555 74245, Operator'S Manual

Page: 43 / 56

43
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
•
Follow all instructions and comply with all
safety messages on the electrolyte container.
Installing the Battery
1. Position battery in tray with terminal posts toward the
engine (Fig. 61).
2.
First, install the positive (red) battery cable to positive
(+) battery terminal.
3. Then install the negative battery cable and ground wire
to the negative (–) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
2 washers (1/4 inch), and 2 locknuts (1/4 inch)
(Fig. 61).
5. Slide the red terminal boot onto the positive (red)
battery post.
6.
Secure the battery with J-bolts, hold down clamp and
2 washers (1/4 inch), and 2 wing nuts (1/4 inch)
(Fig. 61).
1
9
5
2
6
7
10
4
3
8
11
7
m–5598
Figure 61
1. Battery
2. Terminal boot
3. Positive battery cable
4. Negative battery cable
5. Ground wire
6. Bolt, 1/4 x 3/4 inch 7. Washer, 1/4 inch
8. Locknut, 1/4 inch
9. Battery clamp
10. J-bolts
11. Wing nut, 1/4 inch
Removing the Battery
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the machine.
• Do not allow metal tools to short between the
battery terminals and metal parts of the
machine.
Warning
Incorrect battery cable routing could damage the
machine and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always Disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always Reconnect the positive (red) battery
cable before reconnecting the negative (black)
cable.
Warning