Toro Z500 Series Z Master, Operator'S Manual

Page: 34 / 64

6. When oil has drained completely, close the
drain valve.
Note:
Dispose of the used oil at a recycling
center.
Figure 35
1. Oil drain valve 2. Oil drain hose
7. Slowly pour approximately 80% of the
specified oil into the filler tube (Figure 34).
8. Check the oil level; refer to Checking the
Engine Oil Level.
9. Slowly add the additional oil to bring it to the
Full mark.
Changing the Oil Filter
Replace the oil filter every 200 operating hours or
every other oil change.
Note:
Change the oil filter more frequently when
the operating conditions are extremely dusty or
sandy.
1. Drain the oil from the engine; refer to
Changing the Engine Oil.
2. Remove the old filter and wipe the filler
adapter gasket surface (Figure 36).
Figure 36
1. Oil lter 3. Adapter
2. Adapter gasket
3. Pour new oil in through the center hole of the
filter. Fill it up to the bottom of the threads
inside.
4. Allow the filter material to absorb the new oil
for 1 to 2 minutes.
5. Apply a thin coat of new oil to the rubber
gasket on the replacement filter (Figure 36).
6. Install the replacement oil filter to the filter
adapter, turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 2/3 to 1 turn
(Figure 36).
7. Fill the crankcase with the proper type of new
oil; refer to Servicing the Engine Oil.
8. Run the engine for about 3 minutes, stop the
engine, and check for oil leaks around the oil
filter.
9. Check the engine oil level and add oil if needed.
Servicing the Spark Plugs
Check the spark plugs after every 200 operating
hours.
Ensure that the air gap between the center and
side electrodes is correct before installing the spark
plug. Use a spark plug wrench for removing and
installing the spark plugs and a gapping tool/feeler
gauge to check and adjust the air gap. Install a new
spark plugs if necessary.
Type: Champion® RC12YC, Champion®
Platinum 3071 or equivalent
Air Gap: 0.030 inch (0.76 mm)
34