Toro Z453 Z Master 74416TE, Operator'S Manual

Page: 54 / 60

Troubleshooting
Problem Possible Cause Corrective Action
1. Blade control (PTO) is
engaged.
1. Move the blade control
(PTO) to disengaged.
2. Parking brake is not on. 2. Set the parking brake.
3. Operator is not seated. 3. Sit on the seat.
4. Battery is dead. 4. Charge the battery.
5. Electrical connections
are corroded or loose.
5. Check the electrical
connections for good
contact.
6. Fuse is blown. 6. Replace the fuse.
Starter does not crank
7. Relay or switch is
defective.
7. Contact an Authorized
Service Dealer.
1. Fuel tank is empty. 1. Fill the fuel tank with
fuel.
2. Air cleaner is dirty. 2. Clean or replace the air
cleaner element.
3. Dirt in the fuel lter. 3. Replace the fuel lter.
Engine will not start, starts
hard, or fails to keep
running.
4. Dirt, water, or stale fuel
is in the fuel system.
4. Contact an Authorized
Service Dealer.
1. Engine load is excessive. 1. Reduce the ground
speed.
2. Air cleaner is dirty. 2. Clean the air cleaner
element.
3. Oil level in the crankcase
is low.
3. Add oil to the crankcase.
4. Cooling ns and air
passages above the
engine are plugged.
4. Remove the obstruction
from the cooling ns and
air passages.
5. Vent hole in the fuel cap
is plugged.
5. Clean or replace the fuel
cap.
6. Dirt in the fuel lter. 6. Replace the fuel lter.
Engine loses power.
7. Dirt, water, or stale fuel
is in the fuel system.
7. Contact an Authorized
Service Dealer.
1. Engine load is excessive. 1. Reduce the ground
speed.
2. Oil level in the crankcase
is low.
2. Add oil to the crankcase.
Engine overheats.
3. Cooling ns and air
passages above the
engine are plugged.
3. Remove the obstruction
from the cooling ns and
air passages.
54