24
7.
Install shoulder bolts (3/8 x 7/8 inch) and locknuts (3/8
inch) securing spring end plate assemblies to traction
unit (Fig. 32).
1
m–3209
3
2
Figure 32
1. Spring assembly
2. Shoulder bolt, 3/8 x 7/8
inch
3. Locknut, 3/8 inch
8.
Position the mower in front of traction unit.
9.
Rotate PTO drive shaft so holes align with hole in
gearbox shaft and slide together (Fig. 33).
10.
Drive roll pin through hole to secure PTO drive shaft
to gearbox shaft (Fig. 33).
1
2
4
3
M–4532
Figure 33
1. PTO drive shaft
2. Universal joint
3. Gearbox shaft
4. Roll pin
11.
Remove the 4 inch block. Release the latch levers and
push carrier frame down. Latch pins should lock.
12.
Select hole in height–of–cut post corresponding to the
height-of-cut desired. Lift on side and front to align
holes and hairpin cotter (Fig. 34).
2
1
3
m–4856
Figure 34
1. Carrier frame
2. Hairpin cotter
3. Height–of–cut post
Note:
All four hairpin cotters should be in the same hole
location for a level cut.
13.
Tilt carrier frame into its upright position. Refer to
Tilting the Mower on page 19.
14.
Route plenum cable under seat. Raise seat, to gain
access to plenum cable. Install cable into bracket and
install washer and nut (Fig. 35).
3
1
4
5
7
2
2
6
8
m–4851
Figure 35
1. Bracket
2. Plenum cable
3. Washer
4. Nut
5. Plenum
6. Plenum cable guide
7. Plenum latches
8. Blower housing
15.
Install plenum to blower housing and wrap cable
around guide. Refer to Installing and Removing the
Plenum on page 26.
Summary of Contents for Z355 Z-Master
