Toro Z-Stand 105-1621, Installation Instructions Manual

Page: 5 / 8

Installation Instructions
5
1
2
3
m–5374
Figure 8
1. Z–Stand (Positioned in
slot) 2. Crack in side walk or turf
3. Latch resting on pivot tab
8. Drive onto stand. Stop when latch drops over tab into
locked position (Fig. 9). Once onto stand, engage
parking brake. Shut off engine.
9. Chock or block the drive wheels.
Parking brake may not hold machine parked on
Z–Stand and could cause personal injury or
property damage.
Do not park on Z–Stand unless wheels are
chocked or blocked.
Warning
10. Perform maintenance.
11. Remove chocks or blocks.
Driving off the Z–Stand
1. Raise latch to unlocked position (Fig. 9).
2. Start engine and place at half throttle. Disengage
parking brake.
3. Slowly drive backwards off of stand.
4. Remove the cotter hair pins and stand pins (Fig. 7).
5. Push in the inner part of stand and insert stand pins
and cotter hair pins (Fig. 7).
6. Return stand to its rest position (Fig. 6).
7. Insert bracket pin into Z–Stand bracket (Fig. 6).
2
1
4
3
m–5373
Figure 9
1. Z–Stand
2. Latch
3. Locked position
4. Unlocked position