Toro Z MASTER Z588E, Operator'S Manual

Page: 42 / 60

42
Note: Motion control levers must be installed correctly.
See Installing the Motion Control Levers in the set up
instructions.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the seat and tilt the seat forward.
4. Begin with either the left or right motion control lever.
5. Move the lever to the neutral position but not locked
(Fig. 57).
6. Pull lever back until the clevis pin (on arm below pivot
shaft) contacts the end of the slot (just beginning to put
pressure on the spring) (Fig. 57).
7. Check where the control lever is relative to notch in
console (Fig. 56). It should be centered allowing lever
to pivot outward to the neutral lock position.
2
m–6282
1
3
Figure 56
1. Neutral locked position
2. Control lever
3. Neutral position
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Fig. 57).
9. Apply slight rearward pressure on the motion control
lever, turn the head of the adjustment bolt in the
appropriate direction until the control lever is centered
in neutral lock position (Fig. 56).
Note: Keeping rearward pressure on the lever will keep
the pin at the end of the slot and allow the adjustment bolt
to move the lever to the appropriate position.
10. Tighten the nut and jam nut (Fig. 57).
11. Repeat on the opposite side of the machine.
M–6278
1
2
6
7
4
5
10
8
3
9
10 11
11
Figure 57
1. Clevis pin in slot
2. Nut against yoke
3. Adjustment bolt
4. Pump rod
5. Double nuts
6. Jam Nut
7. Spring
8. Pivot shaft
9. Yoke
10. Locknut
11. Ball joint
Setting the Hydraulic Pump
Neutral
Note: Adjust the handle neutral first. That has to be
correct before the following adjustment can be made.
Danger
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
•
Use jack stand when supporting machine.
•
Do not use hydraulic jacks.
Engine must be running so motion control
adjustment can be performed. Contact with
moving parts or hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away from rotating parts, muffler and other
hot surfaces.
Warning
This adjustment must be made with the drive wheels
turning.