2003—The Toro Company
8111 Lyndale Ave., Blomington, MN 55420, USA
Printed in the USA
All Rights Reserved
Original Instructions (EN)
Register your product at www.Toro.com
Z100 Series Z Master
Mowers
Form No. 3329-965
Setup Instructions
Loose Parts
Use steps 1 trough 12 in the following chart to verify all parts have been shipped and as a guide through the
setup.
Step
Description
Qty.
Use
1
No parts needed
–
Raising the machine up
2
Roll bar, right section
Roll bar, left section
Roll bar, center section
Bolt, 3/8 x 1 inch
Curved washer, 3/8 inch
Flange nut, 3/8 inch
Bolt, 1/2 x 3-1/4 inches
Flange nut, 1/2 inch
Lanyard
1
1
1
8
8
8
2
2
2
Installing the roll over protection system
(ROPS)
3
Wheels
2
Installing the drive wheels
4
No parts needed
–
Checking the tire pressure
5
Seat
Nuts (installed on the seat)
1
4
Installing the seat
6
Control lever–right
Control lever–left
Bolt, 3/8 x 1 inch
Curved washer, 3/8 inch
1
1
4
4
Installing the motion control levers
7
Bulk electrolyte with 1.265 specific gravity
(Purchase from a battery supply outlet.)
80
ounces
Activating the battery
8
Air cleaner cap
Hose clamp
1
1
Installing the air cleaner cap
9
Number 2 general purpose lithium base or
molybdenum base grease. (Purchase
separately.)
1 tube
Greasing the bearings
10
No parts needed
–
Preparing the side discharge chute
